RF receiver output connected to uC, RF receiver interface AT89C52

[Help]

Hi,

I bought one RF Receiver.

My question is is it possible we direct connect the receiver output to uC(at89c52) rather than we use the decoder to decode the receiver signal?

As i know the Manchester Coding and Decoding for use with RF Modules...
Encoding: 8 bit byte becomes 16 bits to transmit... zero's become "01" and ones become "10".
Decoding: 16 bits get deconstructed back to 8 bit byte... "01" gets turned back into a zero and "10" gets turned back into a one.
Example... you are sending byte $00 which is equal to %00000000... this get's turned into %0101010101010101.

Here is the article:
http://www.ottawarobotics.org/articles/rf/rf.html

How can use uC to design it? Please guide me...

Thank you.

[uController]

Hello, I don't think you will find much help here. I suggest you go to the Nut's and Volts forum: http://www.servomagazine.com/forum. Tell them that ku7485 had sent you.

[Help]

Hi,

Thank for your reply. ku7485 is your friend? How i goin to tell him you introduce me?

I realy need help on this. Thank You very much.

Thank You

[uController]

ku7485 is my username on the Nuts and Volts forums. Go over to the Nuts and Volts forum, sign up a account and post your question there. Tell them that ku7485 had sent you to that forum.

[Help]

Hi,

Ya, i already do that. Thank You.

I post my question few days already. Do you still have other good forum to recommend?

Thank You.